In Case Of Difficulty - Clarion DXZ558RMP Owner's Manual

Digital Radio / DAB Operations
2. Press the [a, d] lever upward or
downward to select "INFO-S <E>", then
press the [ ] button to enter "INFO-S <E>"
mode.
3. Press the [a, d] lever upward or
downward to select an information item. You
can select any of 6 items:
Travel Warning
Event Special
4. Turn the [ROTARY] knob to set the
information item for ON or OFF.
5. Press the [ ] button to store the setting.
6. Press the [ADJ] button to return to the
previous display.

8. IN CASE OF DIFFICULTY

Problem
Power does not
turn on.
(No sound is
produced.)
No sound output
when operating
the unit with
amplifiers or
power antenna
attached.
Nothing happens
when buttons are
pressed.
Display is not
accurate.
No sound heard.
30
DXZ558RMP
News Weather
Travel ...
Cause
Fuse is blown.
Incorrect wiring.
Power antenna lead is
shorted to ground or
excessive current is required
for remote-on the amplifiers
or power antenna.
The microprocessor has
malfunctioned due to noise,
etc.
DCP or main unit connectors
are dirty.
The speaker protection circuit
is operating.
For the following items, see "RDS
Operations" (page 16)
AF function
∗ If the reception of the current broadcast station
deteriorates, "SEARCHING" appears in the
display and the radio searches for the same
programme on another frequency.
TA (Traffic Announcement)
PTY
Emergency broadcast
Switching the PTY and INFO display
language
Volume setting of TA, INFO emergency
broadcast (ALARM) and PTY
Measure
Replace with a fuse of the same amperage. If the
fuse blows again, consult your store of purchase.
Consult your store of purchase.
1. Turn the unit off.
2. Remove all wires attached to the power antenna
lead. Check each wire for a possible short to
ground using an ohm meter.
3. Turn the unit back on.
4. Reconnect each amplifier remote wire to the
power antenna lead one by one. If the amplifiers
turn off before all wires are attached, use an
external relay to provide remote-on voltage
(excessive current required).
Turn off the power, then
press the [OPEN] button
and remove the DCP.
Press the reset button for
about 2 seconds with a thin
rod.
Wipe the dirt off with a soft cloth moistened with
cleaning alcohol.
1. Turn down sound volume. Function can also be
restored by turning the power off and on again.
(Speaker volume is reduced automatically when
the speaker protection circuit operates).
2. If the sound is muted again, consult our service
department.
Reset button