Table of Contents
Advertisement
Condenser
Evaporator
Source/Sink Heat Exchanger
Components Parts
The systems and subsystems of the PolyTherm
Simultaneous Chiller/Heater are configured and
matched to enhance performance and operating
efficiency:
Frame
The PolyTherm Chiller/Heater frame is constructed of
formed sheet metal externally coated with white
painted finish and coated in black.
ARTC-SVX005B-EN
The condenser is a key chiller/heater component that receives refrigerant in the form of gas
from the compressor and changes it to liquid that absorbs the heat dissipated by a cooling
tower or ground source well system.
The brazed plate heat exchanger that is the evaporator is constructed as a plate package of
corrugated channel plates with filler material between each plate. The filler material forms a
brazed joint at every contact point on the plates, creating complex channels. This allows fluid
to come into close proximity, separated only by channel plates, that enable heat from one
fluid to be transferred to the other with very high efficiency, but without gaskets and frame
parts.
Models with the brazed plate heat exchanger are made of SAE Grade 316 stainless steel and
99.9% copper brazing materials. Interconnecting headers are carbon steel.
Water quality must be verified and maintained by a professional in water treatment and
familiar with the materials of construction and operation of the equipment.
The brazed plate heat exchanger that is the source/sink heat exchanger is
constructed as a plate package of corrugated channel plates with filler
material between each plate. The filler material forms a brazed joint at every
contact point on the plates, creating complex channels. This allows fluid to
come into close proximity, separated only by channel plates, that enable
heat from one fluid to be transferred to the other with very high efficiency,
but without gaskets and frame parts.
Models with the brazed plate heat exchanger are made of SAE Grade 316
stainless steel and 99.9% copper brazing materials. Interconnecting headers
are carbon steel.
Water quality must be verified and maintained by a professional in water
treatment and familiar with the materials of construction and operation of
the equipment.
C C h h i i l l l l e e r r / / H H e e a a t t e e r r D D e e s s c c r r i i p p t t i i o o n n
Cabinet
Cabinet panels are made of sheet metal externally
coated with white painted finish and internally coated
in black. For service, the cabinet enclosure is composed
of easily removable access panels. Access panels are
removable via stainless steel fasteners and retaining
clips.
Strainers
A compact design suction diffuser with stainless steel
40 Mesh strainer is factory-installed on the branch line
15
Advertisement
Table of Contents
