Fisher & Paykel FABRICSMART WA1068P Installation Manual page 8

Levelling instructions
It is IMPORTANT to level the washer to ensure good spin performance.
A level is provided with your washer. The washer is level when the bubble sits in the centre,
within the two lines.
Your washer is equipped with self-locking feet at the front to ensure they do not move once
you have levelled your washer. Move the washer using the top corners, do not push the
centre front of the washer.
After levelling, the corners of the washer should be clear of the floor and the washer must
not rock in any direction.
1
2
3
8
INSTALLATION INSTRUCTIONS
Level
Level
Move the washer to its final position allowing
for required clearances.
Level the washer side to side:
Close the lid and place the level at the centre
back of the lid (near the control panel). Pull
the machine out and adjust the rear feet until
the machine is level side to side.
Level the washer front to back:
Open the lid and place the level on the left
z
side, in line with the centre of the bowl.
Adjust the front left foot (wind down).
z
Repeat the above steps for the right
z
foot. There should be equal weight on
both front feet.
Re-check the washer is level:
Place the level at the centre front of the
z
topdeck (forward of the lid lock slot)
Ensure washer does not rock
z
in any direction.
If washer is not level repeat the above steps
z
Tape the lid down before moving washer.