Fisher & Paykel FABRICSMART WA1068P Installation Manual page 37

Out of balance recovery routine
When your washer is spinning it can sense if the wash load is out of balance. If an out of
balance load is detected, the washer will stop and re-try spinning one more time. If it still
senses an unbalanced load there are two options the washer can take.
Automatic recovery OFF (default setting)
Your washer will stop, beep, and show
screen. You must redistribute the load more evenly yourself. Use this option if you wish to
conserve water.
Automatic recovery ON
Your washer will try to automatically correct the out of balance load. It will fill with water
and agitate to redistribute the load before trying to spin up again.
To change the out of balance (OOB) recovery routine:
1
2
CHANGING PRE-SET OPTIONS
Wash Temp
OOB Recovery OOB Recovery
EOC Beeps
Factory Reset
in three phases on the display
Enter Option Adjustment mode
(refer to the
'OPTION ADJUSTMENT MODE'
for instructions).
Select the
DELICATE
Touch the
MORE
automatic recovery
cycle.
or button to turn
LESS
or .
37