Fisher & Paykel FABRICSMART WA1068P Installation Manual page 10

Draining
Placing the drain hose in a standpipe or tub
Pull hose
through
guide
Flex hose
guide apart
Fitting the drain hose guide
To prevent siphoning the drain hose should not extend more than 20 mm from the end
of the guide. The height of the standpipe or tub should be between 850 – 1200 mm. The
drain hose can be trimmed to length.
Regularly check that your standpipe or tub is free from lint or other obstructions, which
z
may affect how your machine works or may cause flooding.
In multi-storey apartments or any upper floor, the machine should be installed on a floor
z
equipped with a drain.
Draining must comply with local by-laws.
z
Electrical connection
This appliance must be supplied with a 220 – 240V, 50Hz, sinusoidal, 10A electrical supply.
z
Check the power cord for damage, making sure it is not squashed or twisted.
z
A damaged power cord must be replaced by a Fisher & Paykel trained and supported
z
service technician, in order to avoid a hazard.
The appliance must not be operated until it is repaired, as there is a risk of electric shock.
z
SPARE PARTS*
Inlet Valve Cap
Hose Inlet Long (2 m)
Hose Inlet Large Bore
Drain Hose Extension
* Available from your Fisher & Paykel dealer or a Fisher & Paykel trained and supported
service technician.
10
INSTALLATION INSTRUCTIONS
(20 mm)
maximum
1 Carefully pull the drain hose out
from the back of the machine by
pulling the exposed part of the hose
downward and outward.
2 To guide the drain hose over the tub
or standpipe the hose guide MUST be
fitted to the drain hose.
3 Place the drain hose in the tub or
standpipe. Do not fit the hose to a
drain spigot. Drainage must not be
airtight in order to prevent siphoning.
PART NO.
388491P
422680P
426123P
425627P