Table of Contents
Advertisement
Completing your installation
Turn on the water and check all hose connections for leaks. Make sure there are no kinks
z
in the hoses. Check the hose connections for leaks again after 24 hours.
Uncoil power cord, remove and discard the plastic pin cover, and plug into wall socket.
z
Connect the appliance to an earthed outlet protected by a fuse of suitable capacity.
z
IMPORTANT!
Do not touch or operate the washer with wet hands or with bare feet.
Installation test cycle
Your washer must be correctly installed before use. Check the installation and operation of
the washer using the following procedure:
1
2
3
If there are any problems, you must address these before proceeding with normal use. The
washer will automatically turn off at the end of the cycle if there are no problems.
INSTALLATION INSTRUCTIONS
+
Touch
to activate your washer.
Touch both the
and
same time, and hold for three seconds.
Touch
to start the installation test cycle.
The machine will beep to signal the end of
the installation test cycle. Any faults will be
displayed on the screen (refer to the back of
this user guide to help identify faults).
If you need further assistance, please contact
a Fisher & Paykel trained and supported
service technician or our Customer Care
Centre. Refer to 'Customer care' section for
contact details.
buttons at the
OPTIONS
11
- Quick Links:
- Troubleshooting
Hide quick links:
Advertisement
Table of Contents
