Table of Contents
Advertisement
SERVICE ACCESS
We recommend locating the service holes on either side of the DishDrawer™ Dishwasher as
z
shown below.
If the holes are created through wood, ensure the edges are smooth and rounded
z
If the holes are created through metal, ensure the supplied edge protector is fitted.
z
Ensure power cord is routed through a separate service hole to the hoses.
z
SERVICE HOLE DIMENSIONS
A Maximum distance between rear of cavity and service hole
B Maximum distance between floor and service hole
C Minimum diameter of hose service hole
D Maximum diameter of power cord service hole
PREPARATION
REAR
WALL
Hole
location
created
INSIDE
PLAN
to suit
WALL
cabinetry
C
A
C
D
REAR
PROFILE
WALL
B
FLOOR
INCHES
1/4
1/2
2 1/4
1 1/2
1
3/8"
(10mm)
For best results, we recommend installing the supplied sound seal to reduce the possibility of
any excess noise occurring during daily use.
1
MM
5
2
10
57
38
MOISTURE PROTECTION
Align the supplied moisture protection
tape to the cabinetry as illustrated
Ensure this area is free of debris
before carefully applying the tape to
the surface.
SOUND SEAL (OPTIONAL)
Cavity height of 34 – 34 7/16"
(864 – 874mm)
Lay the sound seal flat, do not fold.
Cavity height of 34 7/16" + (874mm +)
Fold the sound seal as illustrated.
Gently tilt the DishDrawer™ Dishwasher
back and align the seal to the front feet.
Carefully lower product and ensure seal
is still positioned correctly.
11
Advertisement
Table of Contents
