Table of Contents
Advertisement
SERVICE ACCESS
Service holes can be created on either side of the DishDrawer™ Dishwasher cavity as
z
shown below.
If the hole is created through wood, ensure the edges are smooth and rounded.
z
If the hole is created through metal, ensure the supplied edge protector is fitted.
z
SERVICE HOLE DIMENSIONS
A Maximum distance between rear of cavity and service hole
B Maximum distance between shelf* and service hole
C Minimum diameter of service hole
D If venting through the adjacent cabinetry, the rear edge of the service hole should be
enlarged by cutting out the bottom corner
*For assisted opening installations, maximum distance should be referenced from the top of the spacer blocks
CABINETRY PREPARATION
A
C
REAR
PROFILE
WALL
B
D
SHELF*
MM
5
10
57
MOISTURE PROTECTION
1
10mm
Align the supplied moisture protection
tape to the cabinetry as illustrated
Ensure this area is free of debris
before carefully applying the tape to
the surface.
11
Advertisement
Table of Contents
