Table of Contents
Advertisement
SERVICE ACCESS
Service holes can be created on either side of the DishDrawer™ Dishwasher cavity as shown
z
below.
If the hole is created through wood, ensure the edges are smooth and rounded
z
If the hole is created through metal, ensure the supplied edge protector is fitted.
z
SERVICE HOLE DIMENSIONS
A Maximum distance between rear of cavity and service hole
B Maximum distance between shelf* and service hole
C Minimum diameter of service hole
D If venting through the adjacent cabinetry, the rear edge of the service hole should be
enlarged by cutting out the bottom corner
*For assisted opening installations, maximum distance should be referenced from the top of the spacer blocks
CABINETRY PREPARATION
A
C
REAR
PROFILE
WALL
B
D
SHELF*
MM
5
10
57
MOISTURE PROTECTION
1
10mm
2
Align the supplied moisture protection
tape to the cabinetry as illustrated
Ensure this area is free of debris.
Carefully apply the tape to the surface.
11
Advertisement
Table of Contents
