Table of Contents
Advertisement
4.4 Ribbon Feed Troubleshooting
Problem
Ribbon doesn't
wind.
Ribbon wrinkles.
･ Print mode is set to
direct-thermal printing.
･ Wrong ribbon path.
･ Ribbon wind direction is
reversed.
･ Ribbon wind tension is
not correct.
･ Tension of ribbon holder
and ribbon winder is not
correct.
･ Print density (heating
factor) is not correct.
･ Angle of ribbon guide bar
is not correct.
･ Ribbon and paper are not
proper.
Note:
If narrow paper is used, the ribbon may wrinkle. Decrease
the right-side head pressure by turning the offset adjustment screw to
prevent the ribbon from wrinkling.
Cause and remedy
®
Change to the thermal-transfer
printing.
®
Use correct path.
®
Set it properly.
®
Set it properly.
®
Set it properly.
®
Correct the parameter of the Hnn
command with the printing
contents definition mode.
®
Contact our service personnel to
adjust the ribbon guide bar.
®
Contact our service personnel.
4-9
Advertisement
Table of Contents
Troubleshooting
