Paper Setting - Citizen CLP-6401 User Manual

3.3 Paper Setting

CAUTION
The printer is designed for easy loading of paper and ribbon. After opening the
cover, set the register paper as follows:
1 Push down the open lever ① to lift the print head up.
2 Push down the open guide lever ③ to lift the sensor arm ② up.
3 Attach the roll paper and roll guide ⑤ to the roll holder ④ and position it in the
paper holder ⑥. After installing the roll paper, adjust the roll guide ⑤ to the
width of the roll paper. The roll paper should be in its deepest position
(reference plane).
4 If necessary, move the paper guide ⑦ out to allow for paper insertion.
5 Set the roll paper as shown in the figure.
6 The left side of roll paper should be flush against the fixed paper guide ⑧.
Adjust the movable paper guide ⑦ to slightly contact the other end of the roll
so that the paper does not skew.
7 Push down the media guide ② until the lever ③ is hooked.
8 Align the paper with the positioning notch of the tear-off plate ⑨ and then
press down the blue tab ⑩ to close the printer mechanism. Press it until it
clicks to ensure proper closure.
9 Close the printer cover.
10 Turn on the power to the printer. The LCD screen on the control panel will
display "On line." Press the Feed key. The paper will advance to the next
label and stop.
(For circled numbers, see figure on next page.)
Be careful of the edges of the plates so injury or
property damage is possible.
3-6