2.4 Printer Setup Mode
To enter the Printer Setup Mode, press and hold down the Pause key then press
the Feed key and release both keys. In a few seconds you will hear a beep and
see Transfer or DirectTM displayed on the LCD screen. The functions of the
control keys are described below.
Changes to the printer configuration are stored in nonvolatile memory. This
guarantees that the printer configuration is maintained even after the power is
turned off.
[Functions]
Print mode selection, peeling sensor ON/OFF, auto-cutter ON/OFF, etc.
n Pause key:
n Feed key:
n Stop key:
Mode item
¯ ¯ ¯ ¯
Direct-thermal/thermal
transfer printing
¯ ¯ ¯ ¯
Peeling sensor
¯ ¯ ¯ ¯
Auto-cutter
¯ ¯ ¯ ¯
Tearing
¯ ¯ ¯ ¯
Sensor selection
2.5 Self-Test Mode
The printer can be placed into self-test mode by pressing and holding the Feed key
while turning the printer on.
Note:
Proper use of this mode requires a minimum label size of 4" x 4". Use of
a smaller label will prevent the user from seeing all printed information,
and verifying the print quality across the entire print head.
Selects the mode.
Selects the mode item.
Saves settings and returns the printer to normal operating mode.
2-4
Indication
Transfer ® Direct TM ®
Peel OFF ® Peel ON ®
Cut OFF® Cut ON ®
Tear OFF ® Tear ON ®
Edge ® Reflect ® ContinuP ®