Set Mode; Set Mode Programming; Set Mode Items - Icom IC-M1V Instruction Manual

8

SET MODE

SET mode programming

SET mode is used to change the condi-
tion of 10 of the transceiver's functions:
beep tone function, weather alert func-
tion, scan type
(normal/priority)
sume timer, auto scan function, auto-
matic backlighting, power save function,
self check function, voice scrambler
type and scrambling code.
When no optional voice scrambler unit
is installed, voice scrambler type and
scrambling code cannot be set. (will not
be displayed)
• SET mode construction
Beep tone
Self check function
16
q Turn power OFF.
w While pushing [MONI], turn power
ON and continue pushing [MONI]
, scan re-
until a beep is emitted.
• After beep emission, release [MONI].
• Set mode item at comment indicator and
condition at channel number readout are
displayed.
r Push [MONI] to select the desired
item, if necessary.
t Push [Y]/[Z] to select the desired
condition of the item.
y To exit SET mode, push [16].
• Turning power OFF, then ON again also
exits SET mode.
Weather alert
Scrambling Scan resume
code
Push
Scrambler
unit selection
Power save
Scan type
timer
Auto scan
Automatic backlighting

SET mode items

× Beep tone "BEEP"
You can select silent operation by turn-
ing the beep tones OFF, or you can
have confirmation beeps sound at the
push of a switch, by turning the beep
tones ON. The beep tone volume is
linked with [VOL].
Push
Beep ON
(default)
Push
Beep OFF