Scan Start/Stop - Icom IC-2100H Instruction Manual

Scan start/stop

D Preparation
Common setting: scan resume condition (p. 41)
For programmed scan: program the scan edges (p. 38)
For memory scan: program 2 or more memory chan-
nels; set memory skip settings, if
desired (p. 40)
D Operation
Select VFO mode for full/programmed scan with [V/MHz];
or memory mode for memory scan with [M/CALL].
Set the squelch to the point where noise is just muted.
Push [ SCAN] for 1 sec. to start the scan.
(V/MHz)
• To change the scanning direction, rotate the tuning dial.
• The memory channel readout indicates the scan type as follows:
X
5 9
1
5 9
1
During full scan
Push [SET] to select full scan
or programmed
scan in sequence.
During programmed scan
Indicates scan edge channels.
• P1 stands for 1A/1b.
• P1 to P3 are available when
they are programmed.
9
5
1
M
To toggle between full and programmed scan, push [SET].
To stop the scan, push [
(V/MHz)
Ä Push [VFO] to select VFO mode for full/pro-
SCAN
grammed scan; or push [MR] to select memory
2
mode for memory scan.
Å Set the squelch to the point where noise is just
muted.
Ç Push [ SCAN] to start the scan.
• [Y]/[Z] also start the scan when pushed and held.
É Push [SET] to toggle between full and pro-
SET
grammed scan.
B
Ñ To stop the scan push [ SCAN].
9
SCAN OPERATION
During memory scan
SCAN].
37