Fisher & Paykel OR30S Gas Gas Installation Manual page 14

3 Fix the stability bracket in place. It can be fixed as follows:
To the floor OR on the rear wall by 4 screws (supplied).
●
To the floor AND on the rear wall by 8 screws (supplied).
●
There are 8 x wood screws and 8 x screws with plastic
●
sleeve anchors supplied with the range in two separate
kits. Use the proper screws according to the type of
material on the floor and/or wall.
If using the the plastic sleeve anchors: drill 5/16" (8mm)
●
diameter holes and insert the supplied anchors before
attaching the stability bracket with the screws.
4 Slide the range into place, ensuring the bolt on the
adjustable bracket slots under the stability bracket.
Adjust the length of the bolt as necessary. Ensure the two
●
nuts are well tightened after any adjustments.
IMPORTANT!
Use the proper screws to fix the stability bracket in place
●
according to the type of material on the floor and/or wall.
Before drilling and holes or inserting any screws into the
●
floor or wall check that you will not damage any wiring or
pipes.
14
!4
INSTALLING THE ANTI-TIP BRACKET
Stability bracket
Stability bracket
Adjustable
bracket with
bolt correctly fitted
Dotted line showing the position
of the range when installed