SAFETY AND WARNINGS WARNING! WARNING! To reduce the risk of fire, injury to persons or damage when using the appliance, follow the important safety instructions listed. Read all guidance before using the appliance. Electric Shock Hazard Servicing Failure to follow this advice may result in Do not repair or replace any part of the appliance unless specifically recommended in the electric shock or death.
COMPONENTS REQUIRED PARTS COMPATIBLE RANGEHOODS Keep all packing materials until the unit has been inspected. Your external blower must be installed with a compatible rangehood. Refer to the range Inspect the product to ensure there is no shipping damage. If any damage is detected hood installation guide.
PRODUCT DIMENSIONS B Ø External blower Roof Ducting g Ø Ceiling Power cords E Ø F Ø SHOWN WITH HP60IDCHEX3 (Compatible Rangehood) PROFILE HB1200E MODELS PRODUCT DIMENSIONS A Overall height B Overall diameter C Height of blower unit D Height of external blower and backdraft damper E Outer diameter of roof pipe F Diameter of ducting outlet G Diameter of grill...
ELECTRICAL REQUIREMENTS VENTING REQUIREMENTS For optimum performance of this blower: 1 Identify roof location where blower noise will be acceptable. This will depend on the following: Distance from outdoor living areas. Transmission of noise through ceiling or windows located near the blower. 2 Mount the blower with 4-6m of ducting.
Page 6
INSTALL EXTERNAL BLOWER When cutting or drilling into wall or ceiling, do not damage electrical wiring and other hidden utilities. WARNING! Failure to install the screws or fixing device in accordance with these instructions may result in electrical hazards. Pass the power cord and plug through 50mm the slot in the roof pipe and out the 50mm...
CONNECT EXTERNAL BLOWER PARTS AND ACCESSORIES ITEM REFERENCE NUMBER External blower Flexible ducting 200mm (6m) 792961 Connect the external blower to the Roof rangehood using the flexible 200mm diameter 6m ducting provided. Ducting Ensure the ducting is: Ceiling Taut, remove excess ducting by trimming to length.
INSTALLER CHECKLIST TO BE COMPLETED BY THE INSTALLER Ensure that: Rangehood is correctly installed All connections are secure The external blower is fitted correctly and securely The ducting is not bent or crushed in any areas ...