Fisher & Paykel HCB36-12 Installation Manual/User Manual page 29

Light bulb replacement
IMPORTANT!
Wear gloves to protect against sharp edges.
● ●
DO NOT TOUCH the light bulb when in use. They may be hot enough to cause injury.
● ●
Note: Replacement bulbs are not covered by warranty.
To replace the light bulb:
Turn off the range hood and allow the light bulb to cool.
● ●
Disconnect the power.
● ●
To remove the light bulb push up and twist counterclockwise.
● ●
Replace with a new 120V, 50W maximum light bulb (or equivalent dimmable LED) light
● ●
with a GU10 base.
Repeat steps for the other light bulbs if needed.
● ●
Reconnect power.
● ●
If new lights do not operate, ensure the bulbs are inserted correctly before calling a
● ●
service representative.
Replacing the infra-red heat lamp (optional accessory)
WARNING!
To avoid any electrical shock the installation of the infra-red heat lamp and panel kit
should be done by a qualified electrician and before starting the installation of the
range hood.
Optional infra-red heat lamp panel can be ordered separately and mounted into your
range hood, see the 'Parts and accessories' section.
Turn off the range hood and allow the infra-red heat lamp to cool.
● ●
Disconnect the power.
● ●
Remove the infra-red heat lamp bulb by twisting counter clockwise.
● ●
Replace with a new 120V, 175W maximum infra-red bulb with a E26 screw in fitting.
● ●
Repeat steps for the other lamp if needed.
● ●
Reconnect power.
● ●
If new lamps do not operate, ensure the bulbs are inserted correctly before calling a
● ●
service representative.
MAINTENANCE
EN
27