Fisher & Paykel HCB36-12 Installation Manual/User Manual page 21

Using two people lift and hang the
!1
range hood using the keyhole slots
(refer to F). Make sure the wood
bracket fits into the recess on the back
of the range hood.
Level the range hood and tighten
!2
the 3/4" (19mm) screws in the keyhole
slots.
From inside the range hood, drive four
!3
or six 3/4" (19mm) screws (depending
on model) through the holes indicated
(refer to G) into the wooden bracket.
Drill a 3/8" (9.5mm) hole through the
!4
center of the holes indicated in H into
the wall. Insert two wall plugs into the
drilled holes. Tighten the range hood
to the wall plugs by installing the
3/4" (19mm) washers onto the screws
supplied with the wall plug, then
tighten.
Attach the duct to the 10" (254mm)
!5
transition or the 8" (203mm) duct
rings and screws (not supplied) and
seal with aluminum tape.
Note: For wall installations the optional duct transition should be fitted to the range
hood prior to wall mounting. Please refer to 'Duct transition assembly' for details.
INSTALLATION INSTRUCTIONS
G
H
EN
F
19