Fisher & Paykel HCB36-12 Installation Manual/User Manual page 22

Professional
Hide thumbs Also See for HCB36-12:
Table of Contents

Advertisement

Available languages

Available languages

Cabinet mounting installation
The range hood can be installed under a cabinet by supporting the range hood from the
top. For cabinet mounting installation the transition should be mounted after installing
the range hood, see 'Duct transition assembly' and 'Product dimensions' sections. If
the transition is used allowance needs to be made in the cabinetry back wall for easier
ducting attachment and sealing.
WARNING!
The cabinet must be of sufficient strength and structurally joined to the wall studs to
support the weight of this range hood.
IMPORTANT!
It is recommended that the cabinet has a door or service panel that can be easily
opened to access the power connection box.
To determine the location for the four
1
screws that will secure the range hood to
the cabinet, refer to 'Product dimensions' for
measurements of
Draw a line to mark distance
2
underside of your cabinet.
At either end of
3
distance
from the wall, the other one at
M
distance
from the wall. This will give you
N
the 4 positions for the screw holes.
Note: Allow space for the power conduit, and
ducting attachment in the cabinetry base.
In the base of the cabinet, drill 1/8" (3mm)
4
holes as marked.
Screw four 3/4" (19mm) screws leaving 1/4"
5
(6mm) of the screw exposed to hang the
range hood on.
Using two people lift and hang the range
6
hood from the screws through keyslots
provided on range hood top (refer to I).
Tighten the four screws.
Drill a 3/8" (9.5mm) hole through the center
7
of the holes indicated in H into the wall.
Insert two wall plug into the drilled holes.
Tighten the range hood to the wall plugs
by installing the 3/4" (19mm) washers onto
the screws supplied with the wall plug, then
tightening.
If using a optional duct transition, attach
8
the 10" (254mm) transition now, see 'Duct
transition assembly' section for details.
Attach the duct to the 10" (254mm) transition
9
or 8" (203mm) duct rings with screws (not
supplied) and seal with aluminum tape.
20
INSTALLATION INSTRUCTIONS
,
and
.
L
M
N
along the
L
, draw two lines, one at
L
N
M
H
L
I

Advertisement

Table of Contents
loading

This manual is also suitable for:

Hcb36-6Hcb30-6Hcb48-12Hc36Hc48Hcb366n

Table of Contents