Installing The Lower Unit - Yamaha F15B Service Manual

LOWR
4. Install the water seal rubber and water
pump housing cover into the water pump
housing assembly, then install the water
pump housing on the lower case.
NOTE:
To install the water pump housing, apply
Yamaha grease A to the inner face of the
water pump housing assembly, and then turn
the drive shaft clockwise while pushing down
on the pump housing.
Water pump housing bolt:
18 N·m (1.8 kgf·m, 13 ft·lb)

Installing the lower unit

1. Install the dowels into the lower case.
6-21
Lower unit
6D460200
6D460210
2. Put the gear shift lever in reverse. Make
sure that the shift rod is in the reverse
position. Install the lower unit onto the
upper case, and tighten the lower case
bolts to the specified torque.
Lower case bolt:
18 N·m (1.8 kgf·m, 13 ft·lb)
NOTE:
9 Screw in the locknut completely.
9 Push the shift rod down to shift into reverse.
3. Connect the shift rod.
NOTE:
Screw the adjuster down until it comes in
contact with the locknut.
4. Install the anode, trim tab (for S-transom)
and inlet covers to their original positions
and tighten the anode bolts to the speci-
fied torque.
Anode bolt:
8 N·m (0.8 kgf·m, 5.8 ft·lb)
6D460220
6D460010
6D45F11