Yamaha F15B Service Manual page 110

POWR
15. Fill the engine oil to specified quantity.
Refer to "Replacing the engine oil" in the
chapter 3.
Recommended engine oil:
4-stroke outboard motor oil
API: SE, SF, SG, SH or SJ
SAE: 10W-30 or 10W-40
Oil quantity:
(oil filter replacement)
1.2 L (1.27 US qt, 1.06 Imp qt)
16. Put the gear shift in neutral.
R
17. Install the manual starter 0 and install
the start-in-gear protection cable q.
q
5-51
Power unit
N
F
6D451590
0
6D451595
q
6D451610
18. Using the adjusting nut w, align the wire
end e with the mark c on the starter
case.
NOTE:
9 Install the spring end of the start-in-gear
protection cable on the starter plunger.
9 Install the start-in-gear protection cable
outer end so that it comes into contact with
the starter case outer end connection point.
9 Install the start-in-gear protection cable
grommet on the starter case, and install the
adjusting nut end of the cable on the lever.
19. Check that the starter rope can be pulled
with the the gear shift in neutral. Also
check that the starter rope cannot be
pulled with the gear shift in forward and
reverse. Adjust the start-in-gear protec-
tion cable if necessary.
20. Install the choke rod, fitting plate and
plate, then tighten the bolts to specified
torques.
Fitting plate bolt:
10 N·m (1.0 kgf·m, 7.2 ft·lb)
21. Connect the oil pressure warning lamp
leads.
e
c
w
6D451625
6D45F11