Offsetting Bumper - Hussmann D5X-ULEP Installation And Service Manual

I
1-10
NSTALLATION

OFFSETTING BUMPER

Offsetting the bumper helps to disguise the joint
locations, giving the lineup a smoother look.
1. Locate starter bumper shipped with the left-
end kit.
2. Remove factory installed bumper by pulling
bumper away from bumper retainer. Be careful
not to lose the internal joint trim on the bumper.
3. If not installed, install bumper end caps as
shown.
Screws
Bumper End Cap
Starter
Bumper
Retainer
Internal Joint Trims
P/N 0501930_A
Bumper Retainer
Merchandiser
Joint
Full Length
Bumper
4. Starting at the left end of the line up, install
the bumper starter section first. To install,
a. Position internal joint trims so that the
first is flush to the left-end panel and the
second is centered between the starter bumper
and the full length bumper as shown.
b. Install full length bumpers and internal
trims offset across joints. Make sure that no
gaps exist between sections. Continue
installing the bumpers the length of line up.
5. Once all except the last section of bumper
have been installed refrigerate the case line up for
at least six (6) hours. The last section of bumper
should be kept inside a cooler or refrigerated
case during this time. This will allow the
bumper to contract.
6. Go to the right end of the line up and tap the
bumper to close any gaps.
7. Measure and cut last sections of bumper. Use
a miter box and fine-tooth saw to cut last bumper
to length. Install the last section.
Bumper
Miter Box
. .
WWW HUSSMANN COM