Hussmann D5X-ULEP Installation And Service Manual page 16

I
1-12
NSTALLATION
2. Apply Gaskets to End Frame as Follows:
5
a. Apply the 1 /
8
of the case as shown. It must be at the edge.
Check to be sure that there are no gaps
between gasket and merchandiser.
5
b. Apply the 1 /
8
the metal frame upright as shown. Check
to be sure that there are no gaps between
merchandiser and gasket.
c. Apply the 1 inch (25 mm) gasket on
the metal case frame as shown across the
bottom. Check to be sure that there are no
gaps between merchandiser and gasket.
F
First Gasket
1 Gasket
in.
(24 mm)
Second
Gasket
5
1 /
in. (41 mm)
8
End Assembly
Tightening order
A, B, C, D, E, F
Silicone Sealant
A
P/N 0501930_A
-inch gasket around the top
in. (41 mm) gasket on
Ultra Low Front
Rear Load
C
O
O
L
E
R
W
A
L
L
d. Apply the 1
the metal case frame as shown the rear.
Check to be sure that there are no gaps
between merchandiser and gaskets.
3. Apply Gaskets to End Assembly
d. Apply the 1 inch (25 mm) gasket to the
back edge of the end assembly from top to
bottom, where the end assembly meets the
cooler wall. Lap gasket if necessary — do
not butt ends. The gasket must fill any gap at
the cooler wall.
Top View of D6X-URLE Top View of D6X-URLE
E
• Do not stretch gasket,
especially around corners.
• Do not butt gaskets;
D
always overlap them as shown.
• Remove paper backing
after gasket has been applied.
• Perimeter gasket required by NSF.
C
• End caps required for rail light.
B
5
/
in. (41 mm) gasket on
8
Cooler Wall Cooler Wall
Top View Top View
IMPORTANT
.
WWW HUSSMANN
1-in. Gasket 1-in. Gasket
(apply top to (apply top to
bottom of bottom of
end assembly) end assembly)
.
COM