Multi-Deck Shelf Alignment; Multi-Deck Shelf Configuration; Installing Fda/Nsf Required Thermometer - Hussmann D5X-ULEP Installation And Service Manual

S
4-2
TART UP

MULTI-DECK SHELF ALIGNMENT

Taped to one of the shelves of each merchandiser
is a small plastic bag containing shelf alignment
strips. These strips are designed to enhance the
appearance of the shelves by aligning the front
edge of each shelf with that of an adjacent shelf.
When installing shelves:
1. Insert one of the alignment strips into the slot
behind the front edge of each shelf.
2. After all shelves are installed, slide the strip
across the shelf joint wherever two shelves
are adjacent. This will lock them together.
Shelf Alignment Strip
5
( / x 6 in. —16 x 152 mm)
8

MULTI-DECK SHELF CONFIGURATION

Shelves are individually mounted in 1 in. (25 mm)
increments and have two-, three-, or four-position
brackets permitting shelves to be placed in a flat
or down-tilt position (see illustration). Front
product stops are recommended when shelves are
placed in the down-tilt position.
P/N 0501930_A
/ O
PERATION
Case performance will be degraded if peg
shelves are used without baffles. Unauthorized
specialty shelving may cause poor case perfor-
mance also. Consult your Hussmann representa-
tive to ensure optimum performance of
Hussmann equipment.
2-Position 3-Position
Note that lighted shelves cannot be used in rear
load merchandisers.
INSTALLING FDA/NSF REQUIRED
THERMOMETER
The following pages provide the same informa-
tion that ships with the thermometer.
This requirement does not apply to display
refrigerators intended for bulk produce (refer
to page 1-1).
Please note that the tape cannot be exposed after
installation.
4-Position
. .
WWW HUSSMANN COM