Apply Gaskets - Hussmann D5X-ULEP Installation And Service Manual

I
1-6
NSTALLATION
Apply Gaskets as Follows:
Right End ONLY
5
1. Apply the 1 / -inch gasket around the top of
8
the case as shown. It must be at the edge. Check
to be sure that there are no gaps between gasket
and merchandiser.
2. Apply the 1 inch (25 mm) gasket on the
metal case frame as shown across the bottom.
Check to be sure that there are no gaps between
merchandiser and gaskets.
5
3. Apply 1 / -inch gasket across the top, from
8
one end of the case to the other, where the case
meets the cooler wall. Lap gasket if necessary
— do not butt ends. The lengthwise gasket must
lap the front-to-back gasket to fill any gap at the
cooler wall.
Apply Silicone Sealant to Right End ONLY
from the top gasket to the bottom gasket as
shown in the illustration.
P/N 0501930_A
IMPORTANT
• Do not stretch gasket,
especially around corners.
• Do not butt gaskets;
always overlap them as shown.
• Remove paper backing
after gasket has been applied.
• Perimeter gasket required by NSF.
• End caps required for rail light.
Apply Gasket Along Full Length
of Case at Cooler Wall
Remove
Insert
Nut Retainers
Alignment
Screws
First Gasket
1 Gasket
in.
(24 mm)
Second
Gasket
5
1 /
in. (41 mm)
8
Silicone
Sealant
Apply Gaskets to
RIGHT END
Insert Remove
Nut Retainers
Alignment
Rod
Alignment Pins
S
I
L
I
C
O
N
C
E
O
O
S
E
R
A
L
W
A
A
N
T
Insert
.
WWW HUSSMANN
L
E
L
L
.
COM