Start-Up Procedure; Perform Auto Scan - Graco G-Flex 1500 Operation

Start-Up Procedure

Start-Up Procedure
***FIRST TIME USE ONLY***
Prior to performing the start-up procedure for the first
time confirm the two halves of the part table are not
touching. This is accomplished by sliding a spacer
down the center of the parts table in between the two
table halves. If the tables are touching see Air Gap
Specification, page 15.

Perform Auto Scan

1. Confirm no parts are on the table or in the hopper.
2. Ensure no person or thing is touching the unit.
3. Press main power switch to the ON position.
4. On the TABLE CONTROL TOUCH PAD, press and
hold the ENTER key to access the main menu.
5. Press DOWN ARROW to select the Frequency sub-
menu and press the ENTER key.
6. Press the UP ARROW three times to select Auto
Scan from the menu.
7. Press the ENTER key to perform an Auto Scan.
8. The table will cycle through different amplitudes and
frequency for about 15 seconds until the resonate
frequency has been found. If the resonate fre-
quency cannot be found, see Troubleshooting
page 23.
9. The table and hopper were Auto Scanned at manu-
facture. The serial label below the POWER IN
JUNCTION BOX (J) lists the natural frequency of
the table and hopper when the G-Flex 1500 was
manufactured.
8
ti21993a
10. Confirm the resonate frequency is between
60-67Hz. If it falls outside of this range, see Trou-
bleshooting page 23.
11. With the table running, press and hold the DOWN
ARROW key until the amplitude is set to a value of
0.0. CFR value will also read 000.0.
12. Press the POWER key on the TABLE CONTROL
TOUCH PAD to turn the part table OFF.
13. Repeat the Auto Scan procedure for the hopper
using the HOPPER CONTROL TOUCH PAD. The
resonate frequency for the hopper should be
between 70-95Hz.
14. With the hopper running, press and hold the DOWN
ARROW key until the amplitude is set to a value of
0.0 CFR value will also read 000.0
15. Press the POWER key on the HOPPER CONTROL
TOUCH PAD to turn the hopper OFF.
For a detailed explanation on all control settings, see
Detailed Control Adjustment, page 12.
ti21921a
ti21922a
ti21922a
332462A