Installation; Floor Preparation; Lifting Instructions - Graco G-Flex 1500 Operation

Lifting Instructions

To prevent crush injury or equipment damage when lift-
™
ing the G-Flex 1500, only use approved (e.g., ANSI)
slings and equipment rated for the weight of the
™
G-Flex 1500 (see Technical Specifications, page
30).
1. Always use BOTH designated mounted lifting lugs
when lifting the G-Flex 1500. See Component
Identification, page 4, for location of lifting lugs.
ti21756a

Installation

When choosing a location for the G-Flex 1500, make
sure the mounting plate is a minimum of 4 in. away from
any other piece of equipment. Refer to the anchor bolt
manufacturer for a minimum edge distance to the con-
crete slab. Follow local regulations in regards to spacing
for control panel access.

Floor Preparation

1. The G-Flex 1500 must be mounted on a level con-
crete surface.
332462A
2. To mount the G-Flex 1500 postition it in the desired
location. The G-Flex 1500 Floor Mounting Plate (J)
is designed to be anchored using four 3/8 in. con-
crete anchor bolts.
3. Use a concrete drill bit of the size recommended by
the anchor bolt manufacturer. Drill 4 holes in the
concrete using the Floor Mounting Plate holes as a
guide. Install the anchor bolts per the manufac-
turer's instructions.
4. A minimum of 1 in. of stud length must protrude
from the floor for proper installation.
5. Install four washers (64) and four nuts (65) provided
to secure the G-Flex 1500 to the concrete surface.
6. Torque to anchor bolt manufacturer recommenda-
tion.
ti21685a
Lifting Instructions
ti21660a
65
64
ti21683a
ti21685a
5