IMPORTANT!
Ensure the door of the appliance is closed when rolling into the cabinetry. DO NOT attempt to open the door until the
appliance is fully installed. The anti-tip bracket and fittings supplied must be fitted to the wall of the finished enclosure
to withstand a 220lb (100kg) load. Ensure that the anti-tip bracket is installed correctly to prevent the possibility of the
appliance tipping forward when the door is open.
WARNING!
Read the following reminders before fastening with masonry plugs and/or screws to avoid serious injury or possible death:
Ensure the screws avoid electrical, gas and water conduits.
●
●
Ensure that the surface where the bracket is fastened can withstand a 220lb (100kg) load.
●
●
Ensure light-weight masonry material such as cinder block and new concrete (no curing time) are not used in installation.
●
●
Do not use metallic materials that may corrode, stain and/or damage the enclosure.
●
●
Project horizontally from the bottom end of the
1
alcove return towards the back wall (A).
– This will locate the contact surface between
the bracket and the appliance.
A
Bracket
Projection must be from
the alcove return towards
the bottom of the bracket
Mark the screw locations of the anti-tip bracket on
2
the wall based on the most central wall stud (B).
– If there are no wall studs, the bracket can be
installed to solid brick walls with masonry
plugs. (However, not recommended to be
used on perforated brick or hollow concrete
bricks).
3
Drill screw holes to the marked locations.
For wooden/plaster board wall installation:
4
Skip to step
.
5
For solid wall installation: Hammer 10x30mm
masonry plugs (4x) into the wall until flush.
Fix the bracket to the wall with 10-12x35mm pan
5
head screws (4x), and screw tightly (C).
18
!3
ATTACH THE ANTI-TIP BRACKET
Wall
Wall
board
stud
B
SINGLE INSTALL
Required components/tools:
Anti-tip bracket assembly
●
●
– 1x Anti-tip bracket
– 4x 10x30mm Masonry plugs
– 4x 10-12x35mm Pan head screws
Cross-head screwdriver
●
●
Marker/pencil
●
●
C
DUAL INSTALL
IMPORTANT!
Make sure the bracket overlaps the appliance
by a minimum 7 1/8" (180mm) for a secure
hold (E).
min 7 1/8"
(180mm)
E
Bracket
Appliance
Wall
If the minimum 7 1/8" (180mm) overlap
cannot be achieved, install a solid spacer to
the wall stud behind the bracket (F).
min 7 1/8"
(180mm)
Bracket
Spacer
Appliance
F
Wall