Attach Anti-Tip Bracket - Fisher & Paykel ACTIVESMART RS36A72 Installation Manuals

IMPORTANT!
Ensure the refrigerator door is closed when rolling into cabinetry.
● ●
DO NOT attempt to open the door until refrigerator is fully installed.
● ●
The anti-tip bracket and fittings supplied must be fitted to the wall of finished enclosure
● ●
to withstand 220 lbs (100kg) load.
Ensure that anti-tip bracket is installed correctly to prevent the refrigerator tipping
● ●
forward when door is open.
Project the end of the above finished enclosure to the
1
center of the back wall and measure 1 1/4" (31mm)
vertically from the projection line (A).
– This will locate the contact surface between
the bracket and the top surface at the back end
of the refrigerator.
(60mm) overlap
A
Mark the screw locations of the anti-tip bracket on the
2
wall based on the most central wall stud (B).
– If there are no wall studs, the bracket can be
installed to solid brick walls with masonry plugs.
(However, not recommended to be used on
perforated brick or hollow concrete bricks.)
B
Drill Ø 1/4" x 1 3/8" (Ø 6mm x 35mm) deep screw holes
3
to the marked locations.
14
!0
For wooden/plaster board wall installation:
4
Fix the bracket to the wall #10x40 pan head
● ●
Phillips screws (4x), and screw tightly (C).
2 3/8" min.
Bracket
For solid wall installation:
5
Hammer masonry plugs (4x) into the wall until flush.
● ●
Fix the bracket to the wall with #10x40 pan head
● ●
Phillips screws (4x), and screw tightly (D).

ATTACH ANTI-TIP BRACKET

WARNING!
Read the following reminders before fastening with masonry plugs and/or screws:
Ensure the screws avoid electrical, gas and water conduits.
● ●
Ensure the surface of the bracket is fastened to withstands a 220.5 pound (100kg) load.
● ●
Ensure light-weight masonry material such as cinder block and new concrete
● ●
(no curing time) are not used in installation.
Do not use metallic materials that may corrode, stain and/or damage the enclosure.
● ●
C
D
IMPORTANT!
When positioning the refrigerator in the cabinetry,
ensure that the bracket overlaps the refrigerator
by a minimum 2 3/8" (60mm) for a secure hold.
2 3/8" min.
(60mm) overlap
If the minimum 2 3/8" (60mm) overlap cannot be
achieved, install a solid spacer to the wall stud behind
the bracket.
2 3/8" min.
(60mm) overlap
Bracket
Bracket
Spacer