Connect To Water And Power Supply - Fisher & Paykel RS2484SR1 Manual

Hide thumbs

Table Of Contents

Table of Contents

WARNING!

The water connection instructions below are intended only for the professional

●

installer.

WARNING — connect to potable drinkable water supply only.

●

DO NOT install on line pressure above 120psi (827kPa) or below 22psi (150kPa).

●

DO NOT use on hot water supply (100°F [38°C max.]).

●

Flush water through the hose prior to connection to the

appliance to remove any debris in the hose.

Move the appliance in front of the cabinetry close

enough that you can access behind for power and water

connections.

Connect a braided water hose to the water supply valve

(A), and insert the free end of the hose through a hole

at the rear of the plinth (B).

Rear view from

back of appliance

Push the hose all the way to the front and connect a

brass adaptor (C).

Note: The adaptor is not required for installation if (1/4")

6.35mm PEX plastic tubing (optional) is used.

Insert the tube end of the adaptor fully into the PRV (D).

Secure the connection with a locking clip between the

PRV and hose end of the adaptor (E).

At the back of your appliance, connect the power cable

to the power supply (115VAC, 60Hz) (F).

– You will hear a chime sound when the appliance is

powered on and automatically goes into 'Installer

(standby) mode'.

– Refer to 'User guide' for more details on activating

the appliance.

Check the connection and open the water supply to test

for leaks.

Note:

The water supply connection is only used for freezer

●

models.

For dual installation, follow the instructions above for

●

both first and second appliances.