Table of Contents
Advertisement
Chapter 2
Blade Switch Installation
Disconnect the BX600 system serial port or the blade switch console port from the PC. See the
Step 12
"Management Options" section on page 1-5
switch.
If you need to rerun the system configuration dialog, see the
section on page
Resetting the Switch Configuration
This section describes how to reset the switch configuration by rerunning the initial configuration dialog
(System Configuration Dialog). These are reasons why you might want to reset the switch:
•
•
Caution
Resetting the switch deletes the configuration and reboots the switch.
To reset the switch, at the switch prompt, enter enable and press Return or Enter. At the Privileged
EXEC prompt,
The switch displays the prompt to run the initial configuration dialog. See the
Configuration" section on page 2-13
Installing and Removing SFP Modules
These sections describe how to install and remove SFP modules. The modules are inserted into the
SFP module slots on the blade switch. These field-replaceable modules provide uplink interfaces.
You can use any combination of SFP modules. Refer to the blade switch release notes for the list of the
supported SFP modules. Each port must match the wave-length specifications on the other end of the
cable, and the cable must not exceed the stipulated cable length for reliable communications. See the
"Installation Guidelines" section on page 2-3
Use only Cisco SFP modules. Each SFP module has an internal serial EEPROM that is encoded with
security information. This encoding provides a way for Cisco to identify and validate that the
SFP module meets the requirements for the blade switch. For detailed instructions on installing,
removing, and cabling the SFP module, refer to your SFP module documentation.
Installing SFP Modules into SFP Module Slots
Figure 2-7
We strongly recommend that you do not install or remove fiber-optic SFP modules with cables attached
Caution
because of the potential damage to the cables, the cable connector, or the optical interfaces in the
SFP module. Disconnect all cables before removing or installing an SFP module.
OL-10694-01
2-15.
You installed the switch in your network and cannot connect to it because you assigned the wrong
IP address.
You want to clear all configuration from the switch and assign a new IP address.
, enter setup and press Return or Enter.
switch#
shows an SFP module that has a bale-clasp latch.
for information about configuring and managing the blade
to re-enter the configuration information and set up your switch.
for cable stipulations for SFP connections.
Cisco Catalyst Blade Switch 3040 for FSC Hardware Installation Guide
Installing and Removing SFP Modules
"Resetting the Switch Configuration"
"Completing the Initial
2-15
Advertisement
Table of Contents
