In Case Of Difficulty; Resetting The Switch Configuration - Cisco Catalyst 3030 Getting Started Manual

In Case of Difficulty

In Case of Difficulty
Troubleshooting Initial Configuration Setup
Did you verify that POST successfully ran
•
before running the initial configuration
dialog?
Did you wait 30 seconds after connecting the
•
switch and the PC before entering the IP
address in your browser?
Did you lock yourself out and forget your
•
password?

Resetting the Switch Configuration

Caution
Cisco Catalyst Blade Switch 3030 Getting Started Guide
1-22
If you experience difficulty, help is available in this section and on Cisco.com.
This section includes initial setup troubleshooting, how to reset the switch, how
to access help online, and where to find more information.
If you have problems running the initial configuration dialog:
This section describes how to reset the switch configuration by rerunning the
initial configuration dialog (System Configuration Dialog). These are reasons
why you might want to reset the switch:
You installed the switch in your network and cannot connect to it because you
•
assigned the wrong IP address.
You want to clear all configuration from the switch and assign a new IP
•
address.
Resetting the switch deletes the configuration and reboots the switch.
Cisco Catalyst Blade Switch 3030 Getting Started Guide
POST errors are usually fatal. Call Cisco
Customer Support immediately if your switch fails
POST.
If not, wait 30 seconds, re-enter 10.0.0.1 in the
browser, and press Enter.
See the "Recovering from a Lost or Forgotten
Password" section in the Troubleshooting
appendix of the software configuration guide if
you forget your password.
78-17052-01