Table of Contents
Advertisement
Appendix C
Configuring the Switch with the CLI-Based Setup Program
Figure C-1
C on so le
Start the terminal emulation session so that you can see the output display from the power-on self-test
Step 2
(POST). The terminal-emulation software—a PC application such as Hyperterminal or
ProcommPlus—makes communication between the blade switch and your PC or terminal possible.
Configure the baud rate and character format of the PC or terminal to match these console port default
characteristics:
9600 baud
•
8 data bits
•
1 stop bit
•
No parity
•
None (flow control)
•
Step 3
Wait for the blade switch to complete the POST. It might take several minutes for the blade switch to
complete POST.
Step 4
Verify that POST has completed by confirming that the system and status LEDs remain green.
If the blade switch fails POST, the system LED turns amber. POST errors are usually fatal. Call Cisco
Systems immediately if your blade switch fails POST.
OL-10694-01
Connecting through the Blade Switch Console Port
16 x
15 x
12 x
14 x
11 x
13 x
16 x
15 x
14 x
13 x
12 x
11 x
Cisco Catalyst Blade Switch 3040 for FSC Hardware Installation Guide
Accessing the CLI Through the Console Port
C-3
Advertisement
Table of Contents
