Table of Contents
Advertisement
Chapter 1
Product Overview
You can do these tasks:
In the Located LED field, choose on or off, and click Apply to locate the blade switch.
•
Under Network Setting, click the URL Address field to open the blade switch web interface.
•
To reset the IP address, the subnet mask, or the gateway address, enter the new settings in the
•
appropriate field, and click Apply and Reload. These settings apply only to VLAN 1. If you are
using a management VLAN other than VLAN 1, the applied settings might not produce the intended
results. See the BX600 system documentation for more information about setting these fields.
To enable polling, click Enable and Apply. The default polling period is 300 seconds. To begin
•
polling immediately, after you click Enable and Apply, click Reset under Reset the Switch Blade.
Before you manage the blade switch from its console port, we recommend that you disable polling.
•
If you configured a password for the blade switch through the management blade console menu, you
must enter that password in the Set Password for Polling Account field, and click Enable.
Otherwise, leave this field blank.
•
Click Reset to reset the blade switch.
For more information about using this interface, see the PRIMERGY BX Blade Server Systems
RemoteView Management Blade User Interface Description.
OL-10694-01
Cisco Catalyst Blade Switch 3040 for FSC Hardware Installation Guide
Management Options
1-7
Advertisement
Table of Contents
