Table of Contents
Advertisement
Blade Switch Installation
This chapter provides instructions on how to install your Cisco Catalyst Blade Switch 3040 for FSC,
referred to as the blade switch, in the Fujitsu Siemens PRIMERGY BX600 S2 system, and to set up and
configure it. The PRIMERGY BX600 S2 system, referred to as the BX600 system, supports up to four
Ethernet blade switches, which are installed in its blade bays. The blade switch is installed in one of the
I/O blade bays on the rear panel of the BX600 system.
This chapter also describes how to interpret the power-on self-test (POST) that ensures proper operation
and how to make connections to the blade switch.
Read the topics and perform the procedures in this order:
•
•
•
•
•
•
•
Preparing for Installation
This section covers these topics:
•
•
•
OL-10694-01
Preparing for Installation, page 2-1
BX600 System Architecture, page 2-4
Overview of Steps for Installing and Initially Configuring the Blade Switch, page 2-6
Installing and Removing SFP Modules, page 2-15
Connecting to the 10/100/1000 Ports, page 2-18
Connecting to SFP Modules, page 2-19
Where to Go Next, page 2-20
Warnings, page 2-2
Installation Guidelines, page 2-3
Verifying Package Contents, page 2-3
C H A P T E R
Cisco Catalyst Blade Switch 3040 for FSC Hardware Installation Guide
2
2-1
Advertisement
Table of Contents
