Table of Contents
Advertisement
Chapter 2
Blade Switch Installation
Figure 2-2
on the right.
Figure 2-2
1
2
3
4
1. A proprietary Intelligent Platform Management Interface (IPMI) connector for Fujitsu
Siemens Computers service applications
2. The KVM connector uses a special cable to connect a VGA monitor, a PS2 keyboard,
and a PS2 mouse.
Table 2-1
Table 2-1
LED
Ethernet port
Master (green)
Failure (amber) On: If only one management blade is installed, it has failed.
For more information about the master and failure management blade LEDs or the advanced KVM
Note
management blade, see the PRIMERGY BX600 Basic Unit Operating Manual.
OL-10694-01
shows the BX600 system management blade on the left and an optional advanced KVM blade
BX600 System Management and Advanced KVM Blades
4
3
2
1
RS-232 serial port
Ethernet port
1
I2C connector
Green master indicator LED
describes the BX600 system management blade LEDs:
Management Blade LED Descriptions
Description
Green: On shows link is up; blinking shows power is on.
Amber: On shows LAN is active; blinking shows power is on.
On: The management blade is the master, responsible for managing the entire
system.
Off: The management blade is a slave—a standby or backup of the master
management blade.
Blinking: The management blade is in special mode.
Off: This management blade is operating normally.
Blinking: The management blade is running in power-on mode, that is, generating
a heartbeat for the master/slave selection.
6
5
5
Failure indicator LED
6
Advanced KVM blade Ethernet port
2
7
KVM connector
Cisco Catalyst Blade Switch 3040 for FSC Hardware Installation Guide
BX600 System Architecture
7
2-5
Advertisement
Table of Contents
