Table of Contents
Advertisement
Accessing the CLI Through the Console Port
These choices appear:
Step 10
[0] Go to the IOS command prompt without saving this config.
[1] Return back to the setup without saving this config.
[2] Save this configuration to nvram and exit.
If you want to save the configuration and use it the next time the switch reboots, save it
in NVRAM by selecting option 2.
Enter your selection [2]:2
Make your selection, and press Return.
Disconnect the blade server serial port or the blade switch console port from the PC. See the
Step 11
"Management Options" section on page 1-5
Cisco Catalyst Blade Switch 3040 for FSC Hardware Installation Guide
C-6
Appendix C
Configuring the Switch with the CLI-Based Setup Program
for information about managing the blade switch.
OL-10694-01
Advertisement
Table of Contents
