Table of Contents
Advertisement
Allegro 20 Disc Publishing System
Service Manual
20.5
Fold and crease carrier flex pc in locations shown. Place holes onto tiny tabs on bracket. Plug
alignment sensor in. Place new carrier flex pc into frame.
Fold
Tabs
Fold
20.6
When reassembling carrier be sure to snap end of quad sensor carrier bracket onto tab on
frame before replacing screw. Be sure to route alignment sensor wires behind tab before
replacing 4 screws securing both frames together. Be sure bottom corners of carrier flex pc are
pinched between both frames.
Snap
Wires Behind
Pinched
Rimage Corporation
Page 36
Advertisement
Table of Contents
