Table of Contents
Advertisement
Allegro 20 Disc Publishing System
Service Manual
20.3
Remove screw securing quad sensor carrier bracket. Remove 2 screws (T8 driver). As both
frames separate, lift carrier flex pc out of assembly.
20.4
Use a small flathead screwdriver to pry and pop sensor out of quad sensor carrier bracket. Press
sensor from new carrier flex pc into bracket until it snaps into place. Be sure sensor is snapped
properly in place so that both tiny round tabs are in notches on bracket (2
nd
picture).
Pry to Remove
Press to Attach
Rimage Corporation
Page 35
Advertisement
Table of Contents
