General Information - Rinnai Pro Series Operation Manual

General information

Installation by a licensed tradesperson
Only a licensed tradespeson can install, adjust, maintain, or service this heat pump. Any work
carried out by a non-licensed tradesperson is illegal and will void any warranty.
Location and positioning
R32 refrigerant models MUST BE installed, operated and stored in a room with a floor area larger
than 4 m .
2
Installation must be in a position that can support the unit's weight. If the chosen location cannot
support the weight of the unit, or the installation is not done properly, the unit may drop and cause
serious injury or damage.
The installer must install drainage piping according to the installation instructions. Improper
drainage may cause water damage to your home or property.
• Do not install the unit in location that may be exposed to combustible gas leaks. If combustible
gas accumulates around the unit, it may cause a fire.
• Do not install the outdoor unit where noise may cause a nuisance, such as near bedrooms or
neighbouring properties.
• Do not install the outdoor unit where it will be exposed to sea wind and salt spray, this will
significantly reduce the durability of the unit.
Genuine Rinnai parts
Only use the included accessories, parts, and specified parts for installation. Using non-standard
parts can cause water leaks, electrical shock, fire, and cause the unit to fail.
Disposal guidelines
This appliance contains refrigerant and other potentially hazardous materials. When
disposing of the appliance, the law requires special collection and treatment. Do not
dispose of this product as household waste. The manufacturer will take back the old
appliance free of charge.
Remote control - inserting and replacing batteries
The remote control comes with two AAA batteries. Put the batteries in place before use.
1. Slide the back cover from the remote control downward, exposing the battery compartment.
2. Insert the batteries, paying attention to match the (+) and (-) ends of the batteries with the
symbols inside the battery compartment.
3. Slide the battery back cover back into place.
Tips for using the remote control
• Must be used within 8 m of the unit
• Unit will beep when the signal is received
• Curtains, other materials, and direct sunlight can interfere with the infrared signal
• If the remote is not going to be used for more than two months remove the batteries
| 5