Warnings And Important Information; Safety And Regulatory Information - Rinnai Enviroflo EHPA250VM Operation & Installation Manual

WARNINGS AND IMPORTANT INFORMATION

SAFETY AND REGULATORY INFORMATION

DO NOT operate this system before reading the manufacturers instructions.
This appliance must be installed, commissioned and serviced by an authorised person in accordance
WARNING
with all applicable local rules and regulations.
Access covers of water heating system components will expose 240V wiring and MUST only be removed
by an authorised person.
This appliance is not intended for use by persons (including children) with reduced physical, sensory or
mental capabilities, or lack of experience and knowledge, unless they have been given supervision or
instruction concerning use of the appliance by a person responsible for their safety.
For continued safety of this appliance it must be installed, operated and maintained in accordance with
the manufacturer's instructions.
Children should be supervised to ensure they DO NOT play with the appliance.
The unit is rated at 15 amps (2 core and earth) so the power mains supplying the unit must have a 15 amp
minimum double pole circuit breaker fitted. If the power supply cord is damaged, it MUST BE replaced by
an authorised person in order to avoid a hazard. Take care not to touch the power connections or plugs
with wet hands.
Care should be taken not to touch the pipe work as it may be HOT!
DO NOT place articles on or against this appliance.
DO NOT store chemicals or flammable materials near this appliance.
DO NOT operate with collectors or covers removed from this appliance.
DO NOT activate heat pump unless cylinder is full of water.
NEVER use a flammable spray such as hair spray, paint, etc near this unit as this may cause a fire.
This appliance uses R290 (propane) refrigerant, which is a flammable gas class 3 according to AS 1677
and must be handled by a refrigeration mechanic with appropriate Australian refrigerant handling licence.
RISK OF FIRE
WARNING Risk of fire / flammable material. If the refrigerant is leaked, together with an external ignition
source, there is a possibility of ignition.
NOTICE TO VICTORIAN CONSUMERS
This appliance must be installed by a person licensed with the Victorian Building Authority.
Only a licensed person will have insurance protecting their workmanship.
So make sure you use a licensed person to install this appliance and ask for your Compliance Certificate.
For further information contact the Victorian Building Authority on 1300 815 127
Rinnai 3 EHPA Heat Pump OIM