Rinnai Pro Series Operation Manual page 7

Additional functions
TURBO
This mode allows you to cool indoor air quickly in summer or warm it quickly in winter. In turbo
mode the fan is set to operate at the maximum output. Attempting to alter the fan speed during
turbo will cancel this mode and return the appliance to manual operation.
When the appliance is operating in AUTO, FAN or DRY modes the turbo function is not available.
ECO (available under cool mode only)
Under cooling mode press ECO, the remote controller will adjust the temperature automatically to
24 °C with a fan speed of auto to save energy. Modifying the mode or adjusting the set temperature
less than 24 °C will stop the ECO operation. Under ECO operation, the set temperature should be
24 °C or above, it may result in insufficient cooling. If you feel uncomfortable press the ECO button
again to stop it.
GEAR
Gear is a function within ECO that caps the compressor speed of the outdoor unit, which reduces
electricity consumption. You will have the option of setting it to 75% or 50%.
CLEAN
Cooling and dehumidifying operations can generate moisture inside the appliance. If the appliance
is not going to be used for a long period (in excess of one month), it is suggested to run the
cleaning operation to remove dust and moisture to help avoid odours. The cleaning operation takes
approximately 35 minutes and the appliance automatically shuts off at completion of the cleaning
cycle.
SLEEP
This function gently regulates the set temperature to prevent excessive, draft free, heating or
cooling during sleep. It allows the set temperature to increase or decrease 0.5-1 °C in an hour, up
to a maximum of 2 °C above or below the set point (over a 10 hour period).
FOLLOW ME
Enables the remote control, when in AUTO, COOL, or HEAT to measure the temperature at
its current location and send this signal to the unit every three minutes. Measuring ambient
temperature from the remote control (instead of the unit itself) will enable the heat pump to
optimise the temperature around you for maximum comfort.
BREEZE AWAY
Drops the fan speed and raises the angle of the horizontal louvre so air is not blown down on
people that may be directly below the unit.
DEFROST (dF)
In heating mode, when frost conditions are detected (thermistor in the outdoor unit), the unit
automatically operates in reverse (lasting no more than ten minutes) to warm up the outdoor coil to
stop it from freezing. This means the indoor unit will stop heating and only run on a low fan speed
until defrost (dF) is completed.
| 7