Table of Contents
Advertisement
August 1, 1985
Slider Drive Wire Replacement
1.
Remove the slider drive wire.
5 of "Slider Removal" section.)
2.
Position the slider lock notch just above the
slider drive pulley.
3.
Thread the bead on the drive wire into the
round hole on the right side of the slider.
4.
Wind the drive wire around the slider drive
pulley three times as shown to the right.
5.
Re-install the slider drive pulley,
NOTE: * Make sure the slider drive pulley engages
properly.
Thread the eye of the drive wire into the slot
6.
on the left side of the slider.
7.
Attach the end of the wire spring onto the eye
and the another end onto the spring anchor.
NOTE: * Make sure that the slider moves smooth-
ly and that the wire does not double over.
5-8
(See step 1 to
.
8.
Re-install the drive wire bracket, slider lock
lever, slider release Iever, harness and slider
rock
spring 1 stud screw and 1 connector
NOTE: *
When re-installing the slider, the front
end of the slider must be in the groove of
the operation panel, and rest on the fiber
optics holder.
Advertisement
Chapters
Table of Contents
