17.4
Adjusting the idle speed
Warning
Danger of accidents The engine may go out spontaneously if the idle speed is set too low.
–
Set the idle speed to the specified value. (Your authorized Husqvarna Motorcycles workshop will be
glad to help.)
–
Clean the outside of the handlebar and the inside of the grip
tube. Mount the grip tube on the handlebar.
–
Attach the throttle cables to the guide plate and route cor-
rectly.
–
Position half-shells
Guideline
Screw, throttle grip
–
Slide on sleeve
movement.
S04501-10
Finishing work
–
Check the play in the throttle cable. (
–
Run the engine until warm.
The cold start button is deactivated – A further ¼ turn
returns the cold start button back to the basic position.
(
p. 21)
Danger
Danger of poisoning Exhaust gases are toxic and
inhaling them may result in unconsciousness and
death.
–
Always make sure there is sufficient ventilation
when running the engine.
–
Use effective exhaust extraction when starting or
running the engine in an enclosed space.
–
Adjust the idle speed by turning idle speed adjusting
1
screw
.
Guideline
Idle speed
S03529-11
Tachometer (45129075000)
TUNING THE ENGINE 17
3
, mount and tighten screws
M6
5 Nm (3.7 lbf ft)
1
and check the throttle grip for ease of
p. 123)
1,400 ... 1,500 rpm
2
.
125