Table of Contents
Advertisement
16
TUNING THE ENGINE
16.4
Changing the mapping
Info
To be able to enable the desired engine characteristic via the Map‑Select switch for riding mode at position II , the desired
mapping must first be selected at the Map‑Select switch for the basic setting.
16.5
Adjusting the idle speed
Danger
Danger of poisoning Exhaust gases are toxic and inhaling them may result in unconsciousness and/or death.
–
When running the engine, always make sure there is sufficient ventilation, and do not start or run the engine in an
enclosed space without an effective exhaust extraction system.
Warning
Danger of accidents The engine may go out spontaneously if the idle speed is set too low.
–
Set the idle speed to the specified value.
16.6
Teaching the throttle valve position
Info
If the control unit detects that the throttle valve idle position needs to be retaught, then the MIL flashes 2x per second.
Switching the mapping from STANDARD to SOFT or ADVANCED
–
Turn switch
SOFT – soft response
ADVANCED – direct response
Switch the mapping from STANDARD to SOFT or ADVANCED
–
Turn switch
STANDARD – balanced response
S00923-10
–
Run the engine until warm.
The cold start button is deactivated – The cold start button is in its basic
position. (
–
Set the idle speed by turning the idle speed adjusting screw
Guideline
Idle speed
Tachometer (45129075000)
Info
Turning counterclockwise lowers the idle speed.
Turning clockwise raises the idle speed.
120311-10
to position II.
to position I.
p. 14)
2,250... 2,350 rpm
80
.
Advertisement
Table of Contents
