Table of Contents
Advertisement
12.10
Installing the lower triple clamp
SERVICE WORK ON THE CHASSIS 12
–
Remove O-ring
–
Remove the lower triple clamp with the steering stem.
–
Remove the upper steering head bearing.
H03683-10
Main work
–
Clean the bearing and sealing elements, check for damage,
and grease.
High viscosity grease (
–
Insert the lower triple clamp with the steering stem. Mount
upper steering head bearing.
–
Check whether upper steering head seal
tioned.
–
Mount protective ring
B01632-10
–
Position the upper triple clamp with the handlebar.
–
Mount screw
–
Mount the clutch line with cable holder
H03684-10
–
Position the fork legs.
Bleeder screws
Info
The compression damping is located in left fork
leg COMP (white adjuster). The rebound damping is
located in right fork leg REB (red adjuster).
Grooves are milled into the side of the upper end of
the fork legs. The second milled groove (from the top)
must be flush with the upper edge of the upper triple
S04824-14
clamp.
4
. Remove protective ring
p. 156)
1
2
3
and O-ring
.
4
, but do not tighten yet.
5
6
are positioned toward the front.
5
.
is correctly posi-
.
59
Advertisement
Table of Contents
