Installing The Main Silencer; Changing The Glass Fiber Yarn Filling Of The Main Silencer - Husqvarna TE 150 2023 Owner's Manual

12.26

Installing the main silencer

12.27

Changing the glass fiber yarn filling of the main silencer

Warning
Danger of burns The exhaust system gets very hot when the vehicle is driven.
–
Allow the exhaust system to cool down before performing any work on the vehicle.
Info
Over time, the fibers of the glass fiber yarn filling escape and the damper "burns" out.
Not only is the noise level higher, but the performance characteristics change.
SERVICE WORK ON THE CHASSIS 12
–
Mount the main silencer with rubber sleeve
spring rings.
–
Mount and tighten screws
Guideline
Remaining screws,
chassis
F02316-10
Preparatory work
–
Remove main silencer. (
Main work
–
Remove screws
–
Pull glass fiber yarn filling
–
Clean the parts that need to be reinstalled and check for
damage.
–
Mount new glass fiber yarn filling
–
Push outer tube
fiber yarn filling and the O-ring.
–
Mount and tighten all screws
Guideline
Screws on main
silencer
V01636-10
Finishing work
–
Install the main silencer. (
1
2
with the washers.
M6 10 Nm (7.4 lbf ft)
p. 70)
1 2
. Pull out inner tube with O-ring
4
from the inner tube.
4
on the inner tube.
5
over the inner tube with the new glass
1
.
M5 7 Nm (5.2 lbf ft)
p. 71)
and the
3
.
71