Using The Machine; Safety Checks - Stiga MPST 84 Li 48 V1 Quick Manual For Use

The bluetooth connection is activated
automatically when the machine is started
and successful connection with the device
is confirmed when the icon in fig. 13.M is
illuminated.

5. USING THE MACHINE

5.1. PRELIMINARY OPERATIONS
• Battery check
Charge the battery fully before using the machine for the first
time after purchase (chap. 6.1).
• Seat adjustment
See figure 14.
• Tyre pressure
1. Connect a compressed air gun with a pressure gauge to
the wheel valve (fig. 15).
2. Adjust the pressure according to the values indicated in
the "Technical Data" chart.
• Preparing the machine before starting work
NOTE This machine can be used to mow lawns in a number
of different ways; before starting, prepare the machine based on
how the lawn is to be mowed.
1. Prepare the machine for cutting and lateral grass discharge
(for models with side discharge only)
2. Pre-set for cutting and chopping grass in the grass catcher
(only for models with rear grass catcher type "III") (fig. 16).
3. Preparation for mowing and rear grass discharge (models
with rear grass catcher only) (fig. 17)
4. Preparation for grass mowing and chopping (only with
corresponding kit for "mulching").
• Positioning the anti-scalping wheels
1. For models with side discharge (fig. 24).
2. For models with rear collection (fig. 25).

5.2. SAFETY CHECKS

• General safety checks
Object
Batteries.
Pushbutton panel controls
and commands
Rear unload guard , grass
catcher.
Electrical cables
Operate the machine
forwards/reverse and
release the drive pedal.
Safety devices
Result
No damage to casing and
cover.
Good condition. No
damage.
Good condition. No
damage. Properly installed.
All insulation intact.
No mechanical damage.
The machine slows down
and stops.
They operate as described
in the next paragraph.
• Safety devices checks
Status operator seated.
Drive pedal in neutral position (pedal
released).
Emergency button deactivated.
Action Fully insert the key
Result the machine is ready to be turned ON.
Status Machine on or in operation.
Action Stand up from the driver's seat.
Result All services are deactivated. The icon in fig.
13.E icon flashes and the icon in fig. 13.P is
illuminated.
Status operator seated.
Drive pedal in forward or reverse position.
Action Attempt to start the machine.
Result The icons in fig. 13.E and fig. 13.O remain ON,
battery LEDs 1, 2, 4 and 5 flash.
Pushbutton panel type "I" and "II"
Pushbutton panel of type "III"
Status Emergency button activated.
Action Attempt to start the machine.
Result The machine switches ON. The icon in fig. 13.E
flashes and the icon in fig. 13.O is illuminated.
Drive and cutting means do not work.
Status Cutting means engaged.
Action Enable the reverse drive without holding down
the reverse mowing consent button.
Result The cutting means disengage.
Status Cutting means engaged.
Action Lift the grass catcher or remove the rear
discharge guard (for rear collection models
only).
Result The cutting means disengage.
Status Machine ON and Operating.
Action Release the drive pedal.
Result The machine slows down and stops.
Status Machine ON and Operating.
Action Perform a test drive.
EN - 6