Troubleshooting - Stiga MPST 84 Li 48 V1 Quick Manual For Use

8. TROUBLESHOOTING

PROBLEM
The machine will not switch on.
Irregular cutting
Unusual vibrations during use.
The icon in fig. 13.E remains ON and
battery LEDs 2 and 5 flash.
Pushbutton panel type "I" and "II"
Pushbutton panel of type "III"
The icon in fig. 13.N flashes. All the
other indications in the push-button
panel (icons/LEDs) remain functional
and visible.
The icons in fig. 13.E and fig. 13.O
remain ON, battery LEDs , 2, and 4 flash.
Pushbutton panel type "I" and "II"
Pushbutton panel of type "III"
Cause
Low battery.
Cutting means sharpening is reduced.
High forward speed in relation to the
height of the grass to be cut.
Cutting means assembly
full of grass.
Cutting means incorrectly balanced.
Cutting means loose.
Loose parts.
Possible damage
Battery current overload caused by:
Work conditions too demanding.
Slope too steep .
Pre-alarm for battery, drive motor and/or
cutting means motor over-temperature
because of:
Work conditions too demanding.
Battery over/under temperature caused
by:
Work conditions too demanding.
Unsuitable environmental conditions.
EN - 9
Solution
Charge the battery (par. 6.1).
Contact an Authorised Service Centre
Authorized.
Reduce forward speed
and/or Increase the cutting height:
Wait for the grass to dry.
Clean the cutting means assembly.
Contact an Authorised Service Centre
authorized for verification,
replacements or repairs.
Reduce forward speed:
Increase the cutting height:
Reduce the forward speed and check
the slope of the ground where you are
working.
Reduce forward speed:
Increase the cutting height:
Turn off the machine, wait for at least 5
minutes and then restart it.
Reduce forward speed:
Increase the cutting height:
Wo r k i n a n e nv i ro n m e n t w i t h
a temperature appropriate for the
machine's operating conditions.