Cisco SCE 1000 2xGBE Installation And Configuration Manual page 80

Initial System Configuration
Note that there is no default for this parameter.
Enter trap manager SNMP version:
Step 13 The maximum number of trap managers is 20.
Would you like to add another SNMP trap manager? [no]:y
Enter up to 20 trap managers as described in step 10 through step 12.
Would you like to add another SNMP trap manager? [no]:
Step 14 Configure the Authentication Failure trap status.
Enable the 'Authentication Failure' trap [no]:
Configure the SCE enterprise trap status.
Step 15
Enable the SCE enterprise traps []:
Step 16 Type the name of the system administrator and press Enter.
Note that there is no default for this parameter.
Enter system administrator contact name []:
E
XAMPLE
Following is a sample SNMP configuration, configuring one trap manager, one GET community,
and one SET community, and enabling the authentication failure trap, as well as all enterprise
traps.
Would you like to enter the SNMP configuration menu? [no]: y
Enable SNMP management? [no]: y
Enter SNMP GET community name[]: public
Enter Access list number allowing access with this community string, use '0'
to allow all: 0
Would you like to add another SNMP GET community? [no]:
Enter SNMP SET community name[]: private
Enter Access list number allowing access with this community string, use '0'
to allow all: 2
Would you like to add another SNMP SET community? [no]:
Would you like to configure SNMP trap managers? [no]: y
Enter SNMP trap manager IP address: 10.1.1.253
Enter SNMP trap manager community string: public
Enter trap manager SNMP version: 2c
Would you like to add another SNMP trap manager? [no]:
Enable the 'Authentication Failure' trap [no]: y
Enable SCE enterprise traps []: y
Enter system administrator contact name []: John Smith
Cisco SCE 1000 2xGBE Installation and Configuration Guide
5-18
Chapter 5 Connecting the Management Interfaces and Performing Initial System Configuration
• To add more entries, type y and press Enter
When all entries have been added, press Enter
•
To disable the Authentication Failure trap, press Enter.
•
To enable the Authentication Failure trap, type y and press Enter.
•
To disable the SCE enterprise traps, type n press Enter.
•
• To enable the SCE enterprise traps, type y and press Enter.
:
OL-7821-05